P0680 - Status Word - WEG CFW-11 User Manual

Options
0 = Inactive
1 = Disable via Run/Stop
2 = Disable via General Enable
3 = Change to Local
4 = Change to Local keeping
commands and reference
5 = Causes a Fault
The following events are considered communication errors:
Anybus-CC communication:
A129 alarm/F229 fault: Anybus is offline

A130 alarm/F230 fault: Anybus access error

The actions described in this parameter are executed by means of the automatic writing of the selected actions
in the respective bits of the interface control words. Therefore, in order that the commands written in this
parameter be effective, it is necessary that the device be programmed to be controlled via the used network
interface (with exception of option "Causes a Fault", which blocks the equipment even if it is not controlled by
network). This programming is achieved by means of parameters P0220 to P0228.
P0680 – STATUS WORD
Range: 0000h to FFFFh
Properties: RO
Access groups
via HMI:
Description:
It allows the device status monitoring. Each bit represents a specific status:
Bits 15 14 13
Function
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Table 3.1: P0313 options
No action is taken and the drive remains in the existing status.
A stop command with deceleration ramp is executed and the
motor stops according to the programmed deceleration ramp.
The drive is disabled by removing the General Enabling and the
motor coasts to stop.
The drive commands change to Local.
The drive commands change to Local, but the status of the
enabling and speed reference commands received via network
are kept, providing that the drive has been programmed to use in
Local mode the commands via HMI, or 3-wire start/stop and
speed reference via either HMI or electronic potentiometer.
Instead of an alarm, the communication error causes an drive
fault, so that a drive fault reset becomes necessary in order to
restore normal operation.
01 PARAMETER GROUPS
∟
49 Communication
∟
111 Status and commands
12 11 10
Description
9 8 7 6 5 4 3 to 0
Default: -