Table of Contents
Advertisement
3
Inserting the needle
.07 .03
Fig. 7 - 03
● Activate the threading aid on the machine head by pressing the key.
● Loosen screw 1.
● Insert the needle as far as possible. The long needle groove must be facing left.
● Tighten screw 1.
● Switch off the threading aid on the machine head again by pressing the key.
1
Setting up
Only change the needle when
the threading aid is activated!
Danger of injury if the machine
suddenly starts running!
Only use needles from the sys-
tem intended for the machine,
see Chapter 3 Specifi cations!
53
Advertisement
Table of Contents
