Set-up
9
Set-up
9
Inserting the needle
.01
24
Observe and comply with all regulations and instructions in this instruction
manual.
Pay particular attention to all safety regulations!
All set-up work may only be carried out by appropriately instructed personnel.
Disconnect the machine from the electricity mains for all set-up work by
operating the main switch or by removing the mains plug!
1
2
Fig. 9 - 01
Bring the needle bar to the top position
1
and loosen the screws 1.
Insert the needles 2 up to the stop (while
doing so, the long needle groove must
2
point to the right).
Tighten the screws 1.
Switch off the machine!
Risk of injury due to accidental
machine start-up!
Only use needles of the system
intended for the machine, see
Chapter 3 Technical Data!