9
Preparation
9
Inserting the needle
.01
2
Fig. 9 - 01
All regulations and instructions in this Instruction Manual are to be observed!
Special attention is to be paid to the safety regulations!
All preparation work is only to be carried out by appropriately trained personnel!
1
Switch the machine off!
Danger due to unintentional
starting of the machine!
Only use needles from the sys-
tem intended for the machine,
see Chapter 3 Specifi cations.
● Raise the needle bar to its highest posti-
on by turning the handwheel.
● Loosen screw 1 and insert needle 2 in
the needle bar as far as it will go.
● Align needle 2 in such a way that the
long needle groove is pointing to the fol-
der station and tighten screw 1.
Preparation
33