9
Set-up
9
Inserting the needle
.01
Fig. 9 - 01
Switch on the machine, see chapter 8.03 Switching the machine on/off.
Call up the threading aid function.
The workholder bar moves out of the needle area, the sewing foot is lowered and the
sewing start is disengaged.
Loosen the screw 1 and insert the needle 2 into the needle bar until you feel it stop.
Adjust the needle 2 so that the long needle groove is pointing forwards and tighten the
screw 1.
Start the sewing process
or
Move the machine to home position.
Observe and comply with all regulations and instructions in this instruction
manual.
Pay particular attention to all safety regulations!
All set-up work may only be carried out by appropriately instructed personnel.
Disconnect the machine from the electricity mains for all set-up work by
operating the main switch or by removing the mains plug!
1
2
Set-up
Switch off the machine!
Risk of injury due to accidental
machine start-up!
Only use needles of the system
intended for the machine, see
chapter 3 Technical Data!
33