Table of Contents
Advertisement
4
Stitch length adjustment
.07 .02
Enter stitch length "0" in programme "Manual", and check that no transport feed occurs. Ad-
just switching plate 1 (screws 2) to stepper motor if required.
● Select function "Tools".
● Select function "Service".
● Select function "Stitch Platen Confi guration"
● Select lift via buttons, e.g. "1".
● Press stitch length button, e.g. "4".
● Carry out a trial stitching and measure stitch length.
● If stitch length is too short or too long, enter the measured value above the selected
stitch length and carry out another trial stitching.
● Repeat until stitch length is correct.
● Carry out setting procedure at each lift height and stitch length.
If bolt 6 should touch the casting in longer stitch lengths, and error 38 is dis-
played, then lever 7 (see chapter 4.05.03 Top, Bottom and Needle Feed Zero
Position) must be adjusted.
Adjustment
1
2
97
Advertisement
Table of Contents
