Reload Factory Default Ip Settings; Load Dhcp Ip Settings (Only Ip Address!) - Lightware MX6x6DVI User Manual

7.3.18. Reload factory default IP settings

Description: After issuing this command over serial connection the router will
reload the factory default IP setup.
Command {IP_CONFIG=!}
Response (Changing IP
Parameters after successful command execution:
Info IP settings can NOT be changed with this protocol command via Ethernet
connection, only via serial port. To change the IP settings via Ethernet, use the
Matrix Controller software (section 4.6.1) or the built-in website (section 5.6).
Default setting can be reloaded by the front panel buttons as well (section 3.3.2).

7.3.19. Load DHCP IP settings (only IP address!)

Description: After issuing this command over serial connection the router will
inquire IP address with DHCP.
Command {IP_CONFIG=D}
Response (Changing IP
Parameters after successful command execution:
Info IP settings can NOT be changed with this protocol command via Ethernet
connection, only via serial port. To change the IP settings via Ethernet, use the
Matrix Controller software (section 4.6.1) or the built-in website (section 5.6).
DHCP can be enabled by the front panel buttons as well (section 3.3.2).
Format
configuration...)CrLf
(DONE!)CrLf or
(FAILED!)CrLf
Parameter Value
IP address 192.168.254.254
port number 10001
Subnet mask 255.255.0.0
Gateway 0.0.0.0
Format
configuration...)CrLf
(DONE!)CrLf or
(FAILED!)CrLf
Parameter Value
Acquired with DHCP
IP address
unchanged
port number
unchanged
Subnet mask
unchanged
Gateway
User's Manual Rev. 1.0
Example
→ {IP_CONFIG=!}
← (Changing IP configuration...)CrLf
(DONE!)CrLf or
Example
→ {IP_CONFIG=D}
← (Changing IP configuration...)CrLf
(DONE!)CrLf or
MX8x8DVI-DL
(FAILED!)CrLf
(FAILED!)CrLf
Page 55 / 75