Learn Edid From Attached Display Device; Status - Lightware MX6x6DVI User Manual

The user can switch and learn EDIDs also in the Last Attached Monitors EDIDs
window. Switching an EDID from this list to an input results dynamic EDID routing.
This means that the emulated EDID changes automatically, if a new monitor is
attached to the output, by simply copying the data from the monitor.

5.4.2. Learn EDID from attached display device

The matrix switcher can learn the EDID from a connected display device and store
it in one of the user programmable memory locations. All the monitor's EDIDs are
listed in the EDID list window, and also in the Last Attached Monitors EDIDs
window.
Step 1. Click the desired monitor's EDID from the list.
Step 2. Click the Learn this EDID to submenu item. A popup window will show the
Step 3. Click on the desired memory location. The lists are refreshed in a few

5.5. Status

Basic device information, such as the installed cards‟ firmware and hardware
revisions are displayed in this window.
Page 44 / 75
Figure 5-5. Dynamic EDID routing
memory locations from 51 to 100, which are available for the user.
seconds, and a message box indicates the change.
Figure 5-6. Learning EDID from display device