Activate Monitoring; Method A: If The Envoy-S Is Associated With A System In Installer Toolkit; Method B: If The Envoy-S Is Not Associated With A System In Installer Toolkit; View System Performance In Enlighten - enphase ENV-S-WM230 Installation And Operation Manual

Activate Monitoring

Register the Envoy-S to monitor the Enphase devices in Enlighten at enlighten.enphaseenergy.com. Once
you have registered the system and successfully installed the Envoy-S, Enlighten sets up an account for
the site owner. When you complete the registration and installation, Enphase sends account information
to the site owner so that they can log in to the Enlighten website and view system performance.

Method A: If the Envoy-S is Associated with a System in Installer Toolkit

a. On your mobile device, go to your Wi-Fi settings and disconnect from the Envoy's AP network.
This should restore Internet connectivity to your device.
b. Return to the Installer Toolkit app and tap the Sync button on the System Overview screen.
c. When you have access to a computer with Internet access, log in to Enlighten and select the
system name from the Activation List on the dashboard.
d. From the activation form, open Array
Builder. To see the Array Builder demo, go to
enphase.com/support/videos.
 If you used Installer Toolkit to build
arrays and scan device serial numbers,
the array(s) are built. Make any
necessary adjustments in Array Builder.
If you did NOT use Installer Toolkit to

build arrays and scan device serial
numbers, create the virtual array in Array
Builder using the installation map as
your reference. (You may need to wait if
the devices have not yet reported to
Enlighten.)

Method B: If the Envoy-S is NOT associated with a System in Installer Toolkit

a. Log into Enlighten and click Add a New System from the installer dashboard.
b. Enter the System, Installer, Owner, and Location information.
c. Enter the Envoy serial number.
d. Click Save to submit the form.
e. After the devices have reported to Enlighten, open Array Builder from the activation form, and
create the virtual array, using the installation map as your reference. To see the Array Builder
demo, go to enphase.com/support/videos.
View System Performance in
Enlighten
Once the array is built and the system
is activated, you can log in to Enlighten
to view site data. Enlighten displays a
graphic representation of the PV
system. It also shows detailed current
and historical performance
information.
23
Envoy-S Metered Multiphase Installation and Operation
© 2016 Enphase Energy Inc. 141-00035 Rev 01