Connecting To Envoy-S; Connect Using The Installer Toolkit App; Method A: Use The Site's Wireless Router To Connect To The Envoy-S; Method B: Create A Wireless Access Point - enphase ENV-S-WM230 Installation And Operation Manual

Connecting to Envoy-S

There are several ways to connect with the Envoy-S to check status or do configuration tasks:
Connect wirelessly using Installer Toolkit

Connect remotely using Enlighten

Connect using a computer or mobile device with the Envoy-S local interface


Connect Using the Installer Toolkit App

The Enphase Installer Toolkit is a mobile app that provides installers with onsite system configuration
capabilities.
Options for establishing a connection between the Installer Toolkit app and the Envoy-S are:
Connect the mobile device to the same LAN as the Envoy-S using the site's wireless router.

Use the Envoy-S to create a wireless Access Point (AP).


Method A: Use the Site's Wireless Router to Connect to the Envoy-S

To use the site's wireless router, select Settings on your mobile device and then select Wi-Fi. Tap the
network you want to join from the list of available networks.

Method B: Create a Wireless Access Point

You can connect to Envoy without using the onsite router by creating a wireless Access Point (AP). Use
the Envoy-S built-in Wi-Fi functionality to do this. AP mode supports use of a mobile device and times out
after eight hours. The AP Mode LED
connect the Envoy-S to Installer Toolkit so that you can track system installation progress.
To start an AP session:
1. Briefly press the AP Mode button to start an 8-hour AP session on the Envoy-S. The AP Mode
LED lights solid green when AP mode is active.
26
Envoy-S Metered Multiphase Installation and Operation
lights solid green when AP mode is active. AP Mode allows you to
AP Mode LED
AP Mode button
© 2016 Enphase Energy Inc. 141-00035 Rev 01