enphase ENV-S-WM230 Installation And Operation Manual page 30

View Cellular Connection Information
When the Envoy-S is using the Mobile Connect modem to connect with Enlighten, select > to view Cellular
Configuration information.
View or Change Ethernet Settings
When the Envoy is using Ethernet to connect with Enlighten, select > to view Ethernet configuration
information. From here you can set up for static IP or reset the IP address, if needed.
WARNING: Do not change the Envoy DHCP setting to use a static IP address unless you
also reserve the same IP address on the broadband router. See the section on DHCP
reservations in the router instructions. Failure to reserve the static IP address on the
router may result in duplicate IP addresses and intermittent Internet connection
problems with the Envoy.
To use a static IP address, select Use Static IP and enter information as needed.

Select Update. The application asks you to confirm:

This may interrupt communications with the Envoy-S and require you to reconnect.
Select OK to continue, or select Cancel.

30
Envoy-S Metered Multiphase Installation and Operation
© 2016 Enphase Energy Inc. 141-00035 Rev 01