GE ImageQuant LAS 4000 Original Instructions Manual page 83

Analysis unit interface
Others
Getting Started with ImageQuant LAS 4000 28-9607-59 AB
Environmental conditions
Operating temperature/humidity conditions
Temperature
Humidity
When the above conditions cannot be satisfied, modify the facilities accordingly.
Transportation/storage conditions
Temperature
Humidity
Installation location conditions
1 Do not install the equipment in an area where the temperature varies widely.
2 Do not install the equipment near a source of heat.
3 Do not install the equipment in an area where it may get wet or flooded.
4 Do not install the equipment in an area where it may be exposed to corrosive gas.
5 Do not install the equipment in a dusty area.
6 Do not install the equipment in an area constantly or excessively exposed to os-
cillations or impacts.
7 Do not install the equipment in an area exposed to direct sunlight.
Operation site
Maximum operating altitude
Overvoltage category category II
Rated pollution applied
USB 2.0
Do not connect the ImageQuant LAS 4000 USB connector to a computer not certified
with UL60950-1 (UL listed) and IEC60950-1.
Noise : 70 dB (A) or lower
:15°C to 28°C (with temperature fluctuation below 10ºC
per hour or lower)
:30 % to 70 % RH (no dew condensation)
: -25°C to 70°C
: 5 % to 100 % RH (no dew condensation)
: Indoors
: 2000 m or lower
: Transient overvoltage
: Pollution Degree 2
7 Reference information
7.1 Main specifications
83