Performing An Exposure; Workflow - GE ImageQuant LAS 4000 Original Instructions Manual

Hide thumbs Also See for ImageQuant LAS 4000:

Table of Contents

4 Operation

4.2 Preparation

4.2.3 Placing the sample

4 Open the IDX door and insert the tray. Place the Epi or Trans trays in position with the side with a

hole facing outwards.

5 Ensure the lens cap is removed and close the IDX door.

4.3 Performing an exposure

This section describes the steps for exposing a sample and saving the image. In this description the

screen images shown are for exposure of an ethidium bromide (EtBr) stained sample. The general

procedure is however similar for all types of sample. For detailed instructions refer to the ImageQuant

LAS 4000 User Manual.

Images may also be obtained by repeated, incremental or programmed exposure of a sample. For

detailed instructions on these types of exposure, refer to the ImageQuant LAS 4000 User Manual.

The workflow for exposing a sample and recording an image is as follows:

Getting Started with ImageQuant LAS 4000 28-9607-59 AB

Table of Contents

Show Quick Links

Table of Contents

Do you have a question about the ImageQuant LAS 4000 and is the answer not in the manual?