GE PACSystems RX3i User Manual page 58

MMENC Configuration
M_ME_NC ADSU COMMREQ Configuration
Parameter
mComreq_Setup[42]
mComreq_Setup[43]
mComreq_Setup[44]
mComreq_Setup[45]
MEPTB Configuration
*Future M_EP_TB ADSU COMMREQ Configuration does not scan the Controller memory, you must use
Point Push interface for this ADSU.
Parameter
mComreq_Setup[46]
mComreq_Setup[47]
mComreq_Setup[48]
mComreq_Setup[49]
MEPTC Configuration
*Future M_EP_TC ADSU COMMREQ Configuration does not scan the Controller memory, you must use
Point Push interface for this ADSU.
Parameter
mComreq_Setup[50]
mComreq_Setup[51]
mComreq_Setup[52]
mComreq_Setup[53]
GFK-2949C
Chapter 6. Configuration of IEC 104 Server Parameters Using COMMREQ
Value Description
m-type Memory Type for ME_NC Object
value Value: 8-%R, 10-%AI, 12-%AQ, 196-%W, 0-unused
address Memory Address for ADSU object
value Value: 1 to maximum (based on memory type)
Length Number of ADSU Objects
*Note Each object is 2 words representing a IEE Float
CPO Refer to Control Point Offset Configuration discussion in Section
6.4.4.
Value Description
m-type unused
value
address unused
value
Length unused
CPO unused
Value Description
m-type unused
value
address unused
value
Length unused
CPO unused
July 2017 49