Pre-Installation Check; Installation Location - GE PACSystems RX3i User Manual

Chapter 2. Installation
2.1

Pre-Installation Check

Upon receiving your RX3i equipment, carefully inspect all shipping containers for damage. If any part
of the system is damaged, notify the carrier immediately. The damaged shipping container should be
saved as evidence for inspection by the carrier.
As the consignee, it is your responsibility to register a claim with the carrier for damage incurred
during shipment. GE Intelligent Platforms will cooperate fully with you, however, should such action
be necessary.
After unpacking the RX3i equipment, record all serial numbers. Serial numbers are required if you
should need to contact Customer Care during the warranty period. All shipping containers and all
packing material should be saved should it be necessary to transport or ship any part of the system.
Verify that all components of the system have been received and that they agree with your order. If
the system received does not agree with your order, contact Customer Care.
If you need technical help, contact Technical Support. For phone numbers and email addresses, refer
to the Contact Information page in the front of this manual.

2.2 Installation Location

This product is intended for use with the RX3i system. Its components are considered open
equipment (having live electrical parts that may be accessible to users) and must be installed in an
ultimate enclosure that is manufactured to provide safety. At a minimum, the enclosure shall provide
a degree of protection against solid objects as small as 12 mm (for example fingers). This equates to
a NEMA/UL Type 1 enclosure or an IP20 rating (IEC60529) providing at least a pollution degree 2
environment. For details about installing RX3i rack systems, refer to PACSystems RX3i System Manual,
GFK-2314.
GFK-2949C July 2017 15