Table of Contents
Advertisement
2.13
REMOVAL OF THE BURNER ASSEMBLY
2.13.1
Remove the burner. To allow burner removal, firstly remove the glass
frame assembly as per section 2.12. The fuel-bed support must be
removed to allow access to the burner fixings. Remove the fuel-bed
support as shown below in figure 18.
Fig. 18
2.13.2
Remove the 3 off screws that hold the burner in position, see figure 19
below.
Fig. 19
Viewed from Top
Fuel-bed Support
Viewed from Top
Three off burner retaining
screws
20
Advertisement
Table of Contents
