Table of Contents
Advertisement
Servicing Notes
Servicing should be carried out annually by a competent person such as a CORGI
registered engineer. This is a condition of the Flavel guarantee schemes.
The service should include visually checking the chimney and fire opening for
accumulations of debris and a smoke test to check for a positive up-draught in the
chimney.
The condition of the pebbles or coals should be checked and if necessary the
whole set should be replaced with a genuine replacement set.
The burner assembly is designed to be removed as a complete unit for ease of
access. After any servicing work a gas tightness check must always be
carried out.
For Diagrams refer to Section 2
4.1
Removing the burner assembly from the fire.
4.1.1
Prepare work area (lay down dust sheets etc.)
4.1.2
Remove the fret cover out of the way and put them in a safe location.
Remove the loose pebbles or coals from the fuel bed. Remove the
fuelbed matrix & front ceramic rails.
4.1.3
Isolate the gas supply and remove the inlet pipe from the appliance
inlet elbow. Unscrew and remove the two nuts and washers which
retain the burner at the base. Remove the burner assembly from the
fire.
4.1.4
To refit the burner assembly. Push the burner to locate against the rear
panel of the Silver Sapphire trim and secure the burner at the base of
the control panel with the two nust and washers. Refit the gas supply
pipe and carry out a gas tightness test. The ash pan cover can now be
re-positioned.
4.2
Removing the Piezo Igniter
4.2.1
Remove the burner assembly as in section 4.1
4.2.2
Disconnect the ignition lead from the piezo and unscrew the
retaining nut on the rear of the control panel. Withdraw the piezo from
the front of the control panel. Re-assemble in reverse order and carry
out a gas tightness test.
SECTION 4
MAINTENANCE
23
Hide quick links:
Advertisement
Table of Contents
