Table of Contents
Advertisement
5.3.3
Operation of the Fire in "TIMER" mode
5.3.3.1
In order to change the mode of operation from "MANUAL" to "TIMER",
press the "SET" button, the fire will then
alternate between the settings until the "TIMER" mode is displayed.
NOTE : The "SET" button allows you to alternate between all modes of
operation :- " MANUAL", "DAY TEMP", "NIGHT TEMP", "TIMER" and
back to "MANUAL". Alternatively, pressing either the "UP" or "DOWN"
arrow allows the unit to revert to "MANUAL" mode. Fire must be in
standby mode (pilot must be lit) for temperature mode to be used.
5.3.3.2
Within the "TIMER" setting mode there are two programmable settings
you can make over a 24 hour period, namely P1 and P2. To set the
timer, ensure the handset is in "TIMER" mode as detailed in section
5.3.3.1 above.
5.3.3.3
To set the P1 timed start setting, press and hold the "SET" button until
the P1 (sun symbol is displayed as per figure 6 below) and the time
flashes. Set the hour by pressing the "UP" (large flame) and set the
minutes (in ten minute increments) by pressing the "DOWN" (small
flame) as necessary, then press "OFF" button to complete the
process. Repeat for the P1 (moon symbol is displayed as per figure
below) Set the hour by pressing the "UP" (large flame) and set the
minutes (in ten minute increments) by pressing the "DOWN" (small
flame) as necessary, then press "OFF" button to complete the process.
Fig. 6
P1 with "Sun"
symbol
illuminated
P1 with
"Moon"
symbol
illuminated
Fig. 7
40
Advertisement
Table of Contents
