Advertisement
Advertisement
Table of Contents
Related Manuals for Flavel EMBERGLOW
Summary of Contents for Flavel EMBERGLOW
- Page 1 Emberglow COAL EFFECT BALANCED FLUE GAS FIRE User Instructions These instructions should be read by the user before operating the appliance and retained for future reference Model No. FEBC00MN is only for use on Natural Gas (G20) at a supply...
-
Page 2: Installation Information
INSTALLATION INFORMATION CONDITIONS OF INSTALLATION It is the law that all gas appliances are installed only by a competent (e.g. CORGI Registered) Installer in G.B. in accordance with the installation instructions and the Gas Safety (Installation and Use) Regulations 1998 as amended. Failure to install appliances correctly could lead to prosecution. -
Page 3: Important Safety Information
ABOUT YOUR NEW EMBERGLOW GAS FIRE The Flavel Emberglow is a decorative fuel effect balanced flue gas fire that incorporates a unique and highly developed fuel bed which gives the realism of a loose coal layout combined with realistic flames and glow. The use of durable hard ceramic material in the construction of the fuelbed components ensures long and trouble free operation. -
Page 4: Operating The Fire
Always keep furniture and combustible materials well clear of the fire and never dry clothing or items either on or near to the fire. Never use aerosols or flammable cleaning products near to the fire when it is in use. The fuel bed remains hot for a considerable period after use and sufficient time should be allowed for the fire to cool before cleaning etc. - Page 5 Extinguishing the Pilot The pilot flame can be extinguished by turning the left hand control knob clockwise to the position marked with a circular dot. WHEN TURNING THE FIRE “OFF” PLEASE ENSURE THAT THE CONTROL VALVE IS TURNED TO THE “OFF” POSITION AND THE PILOT FLAME IS EXTINGUISHED.
- Page 6 IMPORTANT : IF THE BURNER IS EXTINGUISHED FOR ANY REASON YOU MUST ENSURE THAT YOU WAIT A FULL FIVE MINUTES BEFORE ATTEMPTING TO RE-LIGHT THE FIRE. CLEANING WARNING : Before attempting any cleaning operation ensure that the fire has been allowed to fully cool. CLEANING THE CANOPY, FENDER AND PAINTED METAL PARTS The canopy and fender fitted to this fire may is cast iron and will therefore retain it’s looks for the life of the fire.
- Page 7 REMOVING / RE-FITTING THE GLASS FRAME ASSEMBLY The glass frame is held in position by hooking the top flange over the combustion chamber opening at the top as shown in Fig. 3 below. Fig. 3 Glass Frame Assembly locates over lip on top of combustion chamber lid, and drops onto flange as shown.
- Page 8 REMOVAL / RE-FITTING OF THE FUELBED NOTE : The position of the fuel-bed components are critical to the performance of the product. Therefore please ensure that the fuel-bed components are positioned as described in the following section prior to requesting a service call due to soot build up, poor flame pattern etc. Place the fuel-bed rear section centrally in the combustion chamber as shown below in Fig.
-
Page 12: User-Replaceable Parts
accept such waste Protective clothing is not required when handling these articles, but we recommend you follow the normal hygiene rules of not smoking, eating or drinking in the work area, and always wash your hands before eating or drinking. Refit the glass frame as detailed in section on page 7, then light the appliance as detailed on page 4 &...