Table of Contents
Advertisement
Servicing Notes
Servicing should be carried out annually by a competent person such as a
registered engineer. This is a condition of the Flavel Fires guarantee
schemes.
The service should include changing the oxypilot as a condition of the
guarantee and visually checking the chimney and fire opening for accumulations
of debris and a smoke test to check for a positive up-draught in the chimney.
The condition of the coals should be checked and if necessary the whole set
should be replaced with a genuine replacement set.
The burner assembly is designed to be removed as a complete unit for ease of
access. After any servicing work a gas tightness check must always be
carried out.
Manual Control Fires – For Diagrams refer to Section 2
4.1
Removing the burner assembly from the fire.
4.1.1
Prepare work area (lay down dust sheets etc.)
4.1.2
Remove the fascia and put it in a safe location. Remove the glass
panel, unscrewing the top and side retaining brackets, see page 11 &
12 of this manual for diagrams. Carefully lift clear the glass panel.
Remove the coals, front ceramic from the rail and fuel-bed base matrix.
Unscrew the two pozi-drive fixing screws which secure the burner heat
shield and remove it from the fire.
4.1.3
Isolate the gas supply and remove the inlet pipe from the appliance
inlet elbow. Unscrew and remove the four screws which retain the
burner. Remove the burner assembly from the fire.
4.1.4
To refit the burner assembly. Push the base of the control panel fully
into the fire and secure with the four screws. Refit the gas supply pipe
and carry out a gas tightness test. Refit the burner heat shield then
refit the coals / pebbles referring to section 3 for the correct coal layout.
Refit the glass panel and glass panel retaining trims. Refit the fascia
and ashpan cover.
SECTION 4
MAINTENANCE
41
Advertisement
Table of Contents
