Table of Contents
Advertisement
Servicing Notes
Servicing should be carried out annually by a competent person such as a GAS
SAFE registered engineer. The service should include visually checking the
chimney and fire opening for accumulations of debris and a smoke test to check
for a positive up-draught in the chimney. The ODS pilot must be changed as a
condition of the guarantee.
The condition of the fibreback should be checked and if necessary it should be
replaced with a genuine item.
The burner assembly is designed to be removed as a complete unit for ease of
access. After any servicing work a gas tightness check must always be
carried out.
For Diagrams refer to Section 2
4.1
Removing the burner assembly from the fire.
4.1.1
Prepare work area (lay down dust sheets etc.)
4.1.2
Remove the "Kamina" fascia from the product as shown in section 3.3
on page 19 and put it in a safe location.
4.1.3
Remove the glass frame assembly as shown in section 3.4 on page 20
and put it in a safe location.
4.1.4
Isolate the gas supply and remove the inlet pipe from the appliance
inlet elbow. Disconnect the pilot pipe, ignition wire and remove the pilot
retaining screws. Unscrew and remove the two screws which retain the
burner brackets to the base of the fire. Remove the burner from its
location, on the injector
4.1.5
To refit the burner assembly, replace in reverse order and re-fit the glass
frame assembly as shown in section 3.4 on page 20 and the "Kamina"
fascia as described in section 3.3 on page 19.
4.2
Removing the Valve
4.2.1
Prepare work area (lay down dust sheets etc.)
4.2.2
Remove the "Kamina" fascia from the product as shown in section 3.3
on page 19 and put it in a safe location.
4.2.4
Remove the thermocouple retaing nut from the valve, remove the
main pipe, inlet pipe and pilot pipe from the valve.
SECTION 4
MAINTENANCE
21
Advertisement
Table of Contents
