Table of Contents
Advertisement
3.4.2
Replacing the Side Filter
1.
Open the top front cover.
2.
Find the filter cover on the right side plate and simply take out the filter. (See
Figure 3.11).
3.
Replace the filter with a new one.
4.
Replace the top front cover and then fasten it.
3.5
Replacing the Power Supply
ACP-5260 supports various power supply models. To replace the power supply mod-
ule, please proceed as follows.
1.
Turn off the failed power supply module.
2.
Loosen the screw on the failed module and then gently pull the module out by
the handle (see Figure 3.12 and Figure 3.13).
3.
Make sure that the new power supply module is the same rating as the currently
installed one.
4.
Slide the power supply module inward until it locks into the right position, then
tighten the screws.
5.
Return the handle to its original place.
Figure 3.12: Replacing the module of 460W redundant power
Figure 3.11: Replacing the side filter
21
ACP-5260 User Manual
Advertisement
Table of Contents
