Table of Contents
Advertisement
5.3
Wires & Cables for SCSI Storage
There is one 68-pin SCSI flat cable in the accessory package. This cable is for con-
necting the add-on SCSI RAID card/controller and the SCSI backplane. The power
wires of the dual fans should be connected to the alarm board. The three 4-pin power
connectors on the rear side of the SCSI backplane are for connecting the power
wires from the power supply.
Note!
Please be sure to connect these wires and cables well before you install
any SCSI HDD. When you have to take out the SCSI disk drive housing
from the chassis, please disconnect the wires and cables first.
5.4
Installing SCSI Disk Drives
5.4.1
Installing SCSI Disk Drives
Note!
There are various types of 3.5" SCSI HDDs on the market. If you're not
sure which type to choose, please consult with an experienced techni-
cian.
Please follow the installation procedures below.
1.
Open the front door by turning the rotary lock.
2.
Push up the latch on the mobile tray (See Figure 5.5).
3.
Press down the handle of the mobile tray and pull it out as far as it will go. Then
completely take out the tray (Refer to Figure 5.6).
4.
Install a 3.5" x 1"-high SCSI SCA 80-pin HDD by fastening the four screws.
5.
Return the mobile tray with SCSI HDD to the disk drive housing and push it in by
the handle until it is locked into the original position.
6.
Push down the latch to lock the tray into place.
ACP-5260 User Manual
Figure 5.4: Wires and Cables for SCSI housing
32
Advertisement
Table of Contents
