Table of Contents
Advertisement
3.2
Replacing the Cooling Fan
There are four cooling fans located inside the chassis. The cooling fans are low main-
tenance and provide adequate cooling to the system by blowing cool air inward.
There are three cooling fans located on the front of the chassis to suck in fresh air;
one cooling fan is located on the rear of chassis to draw the thermal out.
3.3
Replacing the Filter
The filter functions to block dust or particles from the work environment and greatly
helps to extend the longevity of the system. It is recommended to check and replace
the filter periodically. The filter is located on the front panel. To remove and clean the
filter, simply unscrew the filter cover. Then replace the filter with a new one.
3.4
Replacing the Power Supply
To replace the power supply, please proceed as below.
1.
Unplug the power cord from the power supply.
2.
Remove the top cover
3.
Unplug the ATX power connector from the motherboard, as well as the power
connectors from all disk drives.
4.
Loosen the screws on the rear of the rear panel the power supply bracket.
5.
Replace the power supply with a new one and then fasten it onto the chassis.
6.
Plug the ATX power connector to the motherboard. And plug other power con-
nectors to the disk drives and peripherals.
7.
Return the top cover. Then plug in the power cord.
Figure 3.1 Replacing the filter
11
ACP-1000MB User Manual
Advertisement
Table of Contents
