Installing Cpu Card & Add-On Cards - Advantech ACP-5260 User Manual

2.4 Installing CPU Card & Add-on Cards
ACP-5260 supports up to 20 add-on cards. To install a CPU card or add-on card,
please proceed as follows:
1. Select a vacant PICMG slot for the full-length CPU card, or a PCI/ISA slot for
other add-on cards. Then, remove the corresponding I/O bracket attached to the
rear plate of the chassis.
2. Insert the CPU card (with CPU, CPU cooler, RAM, and necessary cables
installed), or add-on card vertically into the proper slot (See Figure 2.5). For full-
length cards, please make sure that the card bracket has been inserted properly
and the other edge of the card has been inserted into the plastic guiding fillister.
Fasten the card with the screw on top of the I/O bracket.
3. Repeat Steps 2 and 3 if there is more than one CPU card or add-on card.
4. Connect the 9-pin USB wire, power switch wire and system reset switch wire
from the chassis to the CPU card.
5. For the PICMG1.0 Backplane, connect the orange-white wire from the connec-
tor "CN20" on the CPU card to the connector "HCN1" on the backplane. Con-
nect the 4-pin +12 V power connector from the power supply to the CPU card.
6. There are two rows of notches on both sides of the hold-down clamp for insert-
ing rubber cushions into. One side is for PCI cards, while the other side is for
ISA cards. Depending on the card height, the cushions can be inserted upward
or downward. After the rubber cushions have been inserted into the notches,
they will stabilize the add-on cards to protect them from shock and vibration.
7. Replace the hold-down clamp and blower brackets and fasten them.
Figure 2.5: Installing a full-length card
9 ACP-5260 User Manual