Table of Contents
Advertisement
This section provides a set of high-level installation and removal instructions for the BOSS-S1 card.
Topics:
•
Removing the BOSS-S1 card
•
Installing the BOSS-S1 card
Removing the BOSS-S1 card
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage
due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are
shipped with your product.
1
Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.
NOTE:
It is recommended that you always use a static mat and static strap while working on components in the interior
of the system.
2
Open the system.
3
Locate the BOSS-S1 card on the system board.
CAUTION:
To prevent damage to the card, you must hold the card by its edges only.
4
For the modular card, loosen the screw that secures the card to the system board.
5
After ensuring that the PCIe bracket is unobstructed, lift the card to remove it from the connector on the system board.
Deploying the BOSS card
Deploying the BOSS card
3
11
Hide quick links:
Advertisement
Table of Contents
