Supermicro 5038K-i User Manual page 105

(Port 0~ Port 5 ) Hot Plug
Select Enabled to enable hot-plugging support for a port specifi ed by the user,
which will allow the user to replace an sSATA disk drive installed on this port
without shutting down the system. The options are Enabled and Disabled.
(Port 0~ Port 5 ) Confi gure as eSATA
Select Enabled to confi gure the sSATA port specifi ed by the user as an external
sSATA port. The options are Enabled and Disabled.
(Port 0~ Port 5 ) Spin Up Device
On an edge detect from 0 to 1, set this item to allow the PCH to start a COMRE-
SET initialization to the device. The options are Enabled and Disabled.
(Port 0~ Port 5 ) sSATA Device Type
Use this item to specify if the sSATA port specifi ed by the user should be con-
nected to a Solid State drive or a Hard Disk Drive. The options are Hard Disk
Drive and Solid State Drive.
*If the item above "Confi gure sSATA as" is set to IDE, the following items will
display:
SATA Test Mode
Select Enabled to enable SATA Test mode support. The options are Enabled and
Disabled.
sSATA Port 0~ Port 5
This item indicates that as sSATA port specifi ed by the user is installed (present)
or not.
•
Model number of drive and capacity
•
Software Preserve Support
(Port 0~ Port 5 ) sSATA Device Type (Available when an sSATA port is
detected)
Use this item to specify if the sSATA port specifi ed by the user should be con-
nected to a Solid State drive or a Hard Disk Drive. The options are Hard Disk
Drive and Solid State Drive.
*If the item above "Confi gure sSATA as" is set to RAID, the following items will
display:
7-25
Chapter 7: BIOS