Supermicro 5038K-i User Manual page 101

SATA Test Mode
Select Enabled to enable SATA Test mode support. The options are Enabled and
Disabled.
SATA Port 0~ Port 5
This item indicates that a SATA port specifi ed by the user is installed (present) or not.
•
Model number of drive and capacity
•
Software Preserve Support
(Port 0~ Port 5 ) SATA Device Type (Available when a SATA port is
detected)
Use this item to specify if the SATA port specifi ed by the user should be con-
nected to a Solid State drive or a Hard Disk Drive. The options are Hard Disk
Drive and Solid State Drive.
*If the item above "Confi gure SATA as" is set to RAID, the following items will
display:
SATA Test Mode
Select Enabled to support SATA Test mode. The options are Enabled and Disabled.
SATA RSTe Boot Info
Select Enabled to provide full int13h support for the SATA controller that is attached
to a device specifi ed by the user. Please set the CMS Storage OPROM policy to
Legacy for this feature to be effective. The options are Disabled and Enabled.

SATA Mode Options
SATA LED Locate
Select Enabled when an LED or an SPGIO hardware device is attached to the
SATA connections. The options are Enabled and Disabled.
RAID0/RAID1/RAID10/RAID5
Select Enabled to support a selected RAID setting on a SATA device specifi ed
by a user. The options are Enabled and Disabled.
Intel Rapid Recovery Technology
Select Enabled for Intel® Rapid Recovery Technology (IRRT) support to enhance
SATA RAID performance. The options are Enabled and Disabled.
7-21
Chapter 7: BIOS