Checking/ Setting The Switches On The Logic Board - AUMA AM 01.1 Operation Instructions Manual

Operation instructions

14.5 Checking/ setting the switches on the logic board

Figure K: Logic board
S2-2
Actuator controls AUMA MATIC AM/ AMExB/ AMExC
The settings on the logic board are already made in the factory, according to
the order details.
The logic board is located below the Modbus board.
S3-2
S1-2
The setting of the end position seating in end position
CLOSED must be the same on the Modbus board (LED 0 in
default mode, figure J, page 44) and on the logic board
(switch S1-2).
Table 11
DIP switch S2-2
Self-retaining REMOTE
Push-to-run operation REMOTE
Self-retaining LOCAL
Push-to-run operation LOCAL
Blinker transmitter (option)
Torque error: torque switch tripping
(in mid-travel) contained in collec-
tive fault signal (insignificant for
fieldbus interface)
S3-2:
Switching-off in end position OPEN.
Switch position has no influence.
When controlling via Profibus DP,
switching-off is always realised by
limit seating in end position OPEN
Position 1:
Switching-off by limit seating in end
position CLOSED
Position 2:
Switching-off by torque seating in
end position CLOSED
Programming
(ON = pressed)
Direction CLOSE
Direction OPEN
Self-retaining REMOTE
may not be used!
Blinker transm. deact.
Blinker transmitter
must be deactivated!
included
Modbus
not included
47