Setting The Modbus Interface - AUMA AM 01.1 Operation Instructions Manual

Actuator controls AUMA MATIC AM/ AMExB/ AMExC
Modbus

7.11 Setting the Modbus interface

green LED illuminated
ADDRESS MODE ON
20
A correct communication is only possible if the settings of
the baud rate, the parity, and the stop bits agree with the
master settings.
.
The settings are realised on the Modbus interface board.
Loosen screws and remove cover (figure G-1)
Figure G-1
Modbus interface
board
Figure G-2: Modbus interface board
LEDs: 7 6 5 4 3 2 1 0
Operation instructions
Screws
L1 L2 L3 L4
Push buttons:
T1 RESET
T2 MODIFY
T3 CHANGE MODE