Setting The Modbus Interface - AUMA MATIC AMExB 01.1 Instructions Manual

Short instructions

3.11 Setting the Modbus interface

green LED illuminated:
ADDRESS MODE ON
A correct communication is only possible if the settings of
the baud rate, the parity, and the stop bits agree with the
master settings.
The settings are realised on the Modbus interface board.
.
Loosen screws and remove cover (figure F-1)
Figure F-1
Modbus interface
board
Figure F-2: Modbus interface board
LEDs: 7 6 5 4 3 2 1 0
Actuator controls AUMA MATIC AM/AMExB/AMExC
Push buttons:
T1 RESET
T2 MODIFY
T3 CHANGE MODE
Modbus
Screws
L1 L2 L3 L4
13