Load Default; Firmware Version Checking - Sungrow SG500MX Operation Manual

Operation Manual
Tap the cell below the "Compensation" and the keypad appears. Enter the energy compensation
by tapping the keypad;
Tap "Enter" to confirm the setting.
Step 5
6.12

Load Default

Proceed as follows to perform the load default:
Tap "Function" from the default menu;
Step 1
Tap "Set-parameter";
Step 2
Tap "Sys-parameter" after entering the correct password;
Step 3
Tap "Load default" and the password inputting window appears;
Step 4
The password is "1111". The system will be reset after entering the password.
6.13

Firmware Version Checking

User can view the firmware version of LCD and DSP as follows:
Tap "Function" from the default menu;
Step 1
Tap "Set-parameter";
Step 2
Step 3 Tap "Sys-parameter" after entering the correct password;
Tap "Language & Firmware Ver. " and enter into the language and firmware version sub-menu;
Step 4
The firmware version of LCD and DSP is shown at the bottom of the page.
Step 5
6 LCD Menu Operation
27