Load Default; Firmware Version Checking - Sungrow SG1250UD Operation Manual

Operation Manual
Step 3 Tap "system parameter" after entering the correct password.
Tap the "Error of E-total (kWh)" cell and a keypad appears. Enter the energy compensation
Step 4
by tapping the keypad.
Tap "Enter" to confirm the setting.
Step 5
6.14

Load Default

Proceed as follows to perform the load default:
Step 1 Tap "Function" from the default menu.
Step 2 Tap "Setting".
Tap "system parameter" after entering the correct password.
Step 3
Tap "Load default" and the following interface appears.
Step 4
Select "Confirm" or "Cancel" to reset the system parameter setting or cancel the operation.
6.15

Firmware Version Checking

Proceed as follows to view the firmware version of LCD and DSP:
Tap "Function" from the default menu.
Step 1
Tap "Setting".
Step 2
Tap "system parameter" after entering the correct password.
Step 3
DSP_SG1250UD-V11_V1_A
DSP_SG1250UD-V11_V1_A
6. LCD Menu Operation
27