This chapter describes the configuration of scanner communication
parameters. The types of options available depends on the interface
cable you are using.
RS-232 Synapse Cables
IBM PC Keyboard Wedge Synapse Cables
DEC VT520 Keyboard Wedge Synapse Cable
DEC VT220, VT320, VT420 Keyboard Wedge Synapse Cable
Scanner Emulation Synapse Cable
AdaptaScan Pass Through Cable
Important: All programming codes are in the Bar Code Programming
Guide for Hand-Held Scanners (Publication 2755-6.5).
Cable Defaults
To set cable defaults, scan the default label for the interface cable you are
using. Refer to each cable section for a table listing the defaults. The
selections for cable defaults are:
•
Set RS-232 Synapse Cable Defaults
•
Set IBM PC Keyboard Wedge Synapse Cable Defaults
•
Set DEC VT 520 Keyboard Wedge Synapse Cable Defaults
•
Set DEC VT VT220, VT320, VT420 Wedge Synapse Cable Defaults
•
Set AdaptaScan Pass Through Synapse Cable Defaults
Communication Setup (Cable
For This Cable
Chapter
Configuration)
See These Pages:
4-2 through 4-8
4-9 through 4-12
4-13 through 4-15
4-16 through 4-18
4-19 through 4-23
4-24 through 4-29
Publication 2755-6.2
4