Communication Setup (Synapse
Cable)
This chapter describes how to configure scanner communication
parameters. The types of options available depends on the synapse
cable you are using.
For This Cable:
RS-232 Synapse Cables
IBM PC Keyboard Wedge Synapse Cables
DEC VT520 Keyboard Wedge Synapse Cable
DEC VT220, VT320, VT420 Keyboard Wedge Synapse Cable
Scanner Emulation Synapse Cable
Important: All programming codes are located in the
Programming Guide for 2-D Bar Code Scanners (Publication
2755-6.7).
Cable Defaults
To set cable defaults, scan the default label for the synapse cable you
are using. Refer to each cable section for a table listing the defaults.
The selections for cable defaults are:
•
Set RS-232 Synapse Cable Defaults
•
Set IBM PC Keyboard Wedge Synapse Cable Defaults
•
Set DEC VT 520 Keyboard Wedge Synapse Cable Defaults
•
Set DEC VT VT220, VT320, VT420 Wedge Synapse Cable
Defaults
Chapter
See These Pages:
5–2 through 5–8
5–9 through 5–12
5–13 through 5–15
5–16 through 5–18
5–19 through 5–23
Publication 2755-6.4
5