Configuring The Scanner; Scanner Default Settings - Allen-Bradley 2755-HDG-4 User Manual

3–2

Configuring the Scanner

Configuring the Scanner
1. Connect the interface cable to the scanner.
2. Apply power to the interface cable (if required).
3. Scan the SCAN THIS SYMBOL FIRST bar code (found in Bar Code
Programming Guide, see page references below).
4. Then scan the SET SCANNER FOR (SYNAPSE or ADAPTASCAN)
CABLE OPERATION bar code.
5. Select the scanner cable type. Scan ENABLE SYNAPSE CABLE if
you are using one of the Synapse cables (RS-232, keyboard wedge, or
scanner emulation). Scan the ENABLE ADAPTASCAN PASS
THROUGH CABLE bar code if you are using the AdaptaScan Pass
Through cable (Catalog No. 2755-HDC-GA2-08).
Note: The scanner stores the Synapse cable and AdaptaScan pass
through cable configurations separately. To change between
configurations, scan the ENABLE SYNAPSE CABLE or ENABLE
ADAPTASCAN PASS THROUGH CABLE bar code.
6. Configure the scanner by scanning the bar codes for the options you
want to change. The scanner is currently set with default settings as
listed on this and the following page.

Scanner Default Settings

Item
Cable Type
Symbologies
Transmit UPC-A Check Digit
Transmit UPC-E Check Digit
Convert UPC-E to UPC-A
EAN Zero Extend
Publication 2755-6.2
Default Setting
AdaptaScan Pass
Through Cable
All Enabled
Enabled
Enabled
Disabled
Disabled
Programming Guide
Page Reference
For AdaptaScan
Cable
2-2
2-4
2-8
2-8
2-8
2-9
For All Other
Cables
1-2
1-4
1-8
1-8
1-8
1-9