Allen-Bradley 2755-HDG-4 User Manual page 28

Power Supply
(May not be required
see previous page.)
Note: The power supply
should be connected last.
To Host
Keyboard Connector
To connect the scanner cable to the keyboard wedge cable, push the
cable into the connector until you hear the connector snap in place. To
remove the scanner cable, press down on the small raised bump on the
connector end and remove cable.
ATTENTION: Do not install the wedge cable or
disconnect/connect the keyboard with power applied to
!
either the wedge cable or host device. Failure to follow
this caution may result in damage to the scanner, wedge
interface cable, or host device.
The wedge Synapse cable connects between the keyboard and the host
device. Unplug the keyboard and connect one end of the wedge cable to
the host keyboard input. Connect the other end of the wedge interface
cable to the keyboard.
Connecting and Operating Scanner
Scanner Cable
Wedge Synapse Cable
(2755-HFC-SP1-01 shown)
To Keyboard
2-9
Scanner
Publication 2755-6.2