Automatic Shutoff; Audible Response - Allen-Bradley 2755-HDG-4 User Manual

2-18 Connecting and Operating Scanner

Automatic Shutoff

The scanner automatically stops scanning after a bar code symbol has
been read. The length of time the scanner remains on without reading a
label is configurable from 0.5 to 3 seconds. You must release and press
the trigger again to resume scanning.

Audible Response

When scanning a bar code symbol, listen for a single short beep from the
scanner. This beep indicates that the bar code has been successfully
scanned. Refer to the following tables for all other responses:
Beep During Normal Operation
This Response
1 Beep (short high tone)
4 Beeps (long, low tone)
Beep During Configuration
This Response
1 Beep (short high tone)
1 Beep (low / high tone)
1 Beep (high / low tone)
1 Beep (high / low / high / low tone)
Publication 2755-6.2
Indicates
Bar code symbol decoded. Scanner audible
response must be enabled.
Format or transmission error detected. This error
occurs if the scanner is not properly configured. All
data is ignored. Verify option settings.
Indicates
Bar code symbol decoded. Scanner audible
response must be enabled.
Input error. Possible causes:
Incorrect bar code scanned
Cancel scanned
Incorrect configuration sequence
Bar code scanned requiring a value. Scan in the
value using the configuration bar codes.
Configuration setting successfully changed.