Operating The Scanner - Allen-Bradley 2755-HDG-4 User Manual

Operating the Scanner

1. Check your connections.
• Is the scanner cable securely attached?
• Is the scanner cable securely connected to the
Synapse cable?
• If a power supply is required, is there power
to the power supply and is the power supply
plugged into the Synapse cable?
2. Test the scanner
Aim the scanner at the work
surface and press the trigger.
You should see the red beam
on the work surface, and the
red LED on the back of the
scanner should be on.
3. Scan a label.
Scan a bar code. Adjust the
scanner position so that the scan
beam is centered on the bar
code and overlaps both sides.
When the scanner has read a
symbol:
• You will hear a beep from the
scanner (if symbology has
been enabled, all symbolo-
gies enabled at default).
• The green LED will turn on
and remain on until the next
scan.
Connecting and Operating Scanner 2-17
Publication 2755-6.2