Rs-232 Synapse Cable Defaults - Allen-Bradley 2755-HTG-4 Programming Manual

2–2
Set RS-232 Synapse Cable Defaults
Scan this label to set the default settings for the RS-232 Synapse
cable. Defaults are indicated with an asterisk.
Scan this label to set the RS-232 Synapse cable to the default settings
shown below.
RS-232 Synapse Cable Parameters
Host
Baud Rate
Parity
Check Parity
Stop Bits
Data Bits
RTS State
Hardware Handshaking
Software Handshaking
Beep on BEL
Unknown Characters
Response Timeout
Parameter Set
Scan the bar code symbols for the settings you need to change.
Publication 2755-6.7
RS-232 Synapse Cable
Set RS-232 Synapse Cable Defaults
Default Setting
Standard RS-232
9600
None
Enabled
1
8
Low
None
None
Disabled
Send Bar Codes With Unknown
Characters
2 Seconds
Set #1
Code on
Page:
2–3
2–4
2–5
2–5
2–6
2–6
2–7
2–7
2–8
2–9
2–9
2–10
2–12