Laser Control And Audible Response Options - Allen-Bradley 2755-HDG-4 User Manual

Laser Control and Audible Response Options

Beep After Decode
When enabled, the scanner will beep after a symbol has been decoded.
We recommend that you leave this option enabled.
Laser On Time Out
This setting determines the maximum time the scanner remains on while
the trigger is pressed. The time out is programmable in 0.5 second
increments from 0.5 seconds to 5.0 seconds.
Hands-Free Stand Operation Timeout
If the scanner is used with an adjustable stand (Catalog No.
2755-HFN-K1, -K2), the scanner operates without pressing the trigger.
Refer to Appendix C for hands-free operation. The timeout determines
how long the scanner scans for a label before reducing the scan rate and
beam intensity. The scanner will resume scanning at the normal rate
when a label is presented. The timeout is selectable in 15 minute
intervals between 15 and 90 minutes.
Power Mode
Determines whether or not the scanner power remains on after a decode
attempt. With low power mode enabled, the scanner powers down after
each attempted decode. With continuous power mode enabled, the
scanner remains on at all times. We recommend that you use the
following settings:
•
low power mode for AdaptaScan Pass Through cable
•
continuous power mode for Synapse cables
Note: When the scanner is in low power mode and a label is scanned,
the first character of the first symbol will not be read as the scanner
powers up. Use continuous mode if this causes a problem with your
application (such as stand mode or A-B Basic Module applications).
Configuring the Scanner 3–17
Publication 2755-6.2