Connecting An F1-F7 Fan (Fan F3 Example) - Enterasys SSA-T1068-0652 Hardware Installation Manual

6. To ensure proper air flow, connect the new fan to the chassis connector with the label side of
the replacement fan facing into the SSA and the cable clip on the right. See Figure
Do not remove the cable clip on fans F1–F7. See Figure
cable clip.
Figure 3-8 Connecting an F1–F7 Fan (Fan F3 Example)
1 Fan F3 connector
7. Place the fan in the chassis next to the connector. See Figure
8. Reinstall the side panel of the SSA.
You can now reinstall the SSA in the equipment rack.
3‐9 on page 3‐12, which shows the
2 Fan F3 (label facing into the SSA)
Enterasys S-Series Stand Alone (SSA) Hardware Installation Guide 3-11
Replacing the SSA Fans
3‐8.
3‐8.