Adapter Wiring And Signal Assignments; Completing The Installation - Enterasys SSA-T1068-0652 Hardware Installation Manual

Completing the Installation

Adapter Wiring and Signal Assignments

COM Port Adapter Wiring and Signal Diagram
RJ45
Pin
1
4
5
2
6
RJ45 Connector (Female)
VT Series Port Adapter Wiring and Signal Diagram
RJ45
Pin
4
1
6
5
2
Completing the Installation
After installing the SSA and making the connections to the network, access the device
management startup screen from your PC or terminal connection as described in the following
section.
2-20 Installation
Conductor
Blue
Red
Green
Orange
Yellow
Pins
1 8
Conductor
Red
Blue
Yellow
Green
Orange
Pins
1 8
RJ45 Connector (Female)
Note: This procedure applies only to initial log-in and to logging in to a device not yet configured
with administratively-supplied user and password settings.
By default, the SSA is configured with three user login accounts: ro for Read-Only access; rw for
Read-Write access; and admin for super-user access to all modifiable parameters. The default
password is set to blank (null). For information on changing these default passwords, refer to the
Enterasys S-Series Configuration Guide
DB9
Pin Signal
2 Receive (RX)
3 Transmit (TX)
5 Ground (GRD)
7 Request to Send (RTS)
8 Clear to Send (CTS)
Pins
5
9
DB9 Connector (Female)
DB25
Pin Signal
2 Transmit (TX)
3 Receive (RX)
5 Clear to Send (CTS)
7 Ground (GRD)
20 Data Terminal Ready
Pins
13
25
DB25 Connector (Female)
.
Pin Out Descriptions
1
6
1
14