Enterasys SSA-T1068-0652 Hardware Installation Manual page 45

Pin Out Descriptions
Start the Command Line Interface (CLI) from the device's local console port as follows:
1. Connect a terminal to the local console port as described in "Connecting to the COM Port for
Local Management" on page 2‐18. The startup screen displays.
login: admin
Password:
SSA
Command Line Interface
Enterasys Networks, Inc.
50 Minuteman Rd.
Andover, MA 01810-1008 U.S.A.
Phone:
E-mail: support@enterasys.com
WWW:
(c) Copyright Enterasys Networks, Inc. 2009
Chassis Serial Number:
Chassis Firmware Revision: xx.xx.xx
SSA (su)->
2. At the login prompt, enter one of the following default user names:
–
–
–
3. Press Enter.
4. The Password prompt displays. Leave this string blank and press Enter. The device
information and SSA prompt appear as shown above.
The SSA is now ready to be configured. For information about setting the IP address and
configuring Telnet settings for remote access to SSA management, refer to the Enterasys S‐Series
Configuration Guide.
The CLI commands enable you to initially set up and perform more involved management
configurations. The Enterasys S‐Series Configuration Guide is available online at:
http://www.enterasys.com/support/manuals
+1 978 684 1000
http://www.enterasys.com
ro for Read‐Only access
rw for Read‐Write access
admin for Super User access. (This access level allows Read‐Write access to all modifiable
parameters, including user accounts.)
xxxxxxxxxxxx
Enterasys S-Series Stand Alone (SSA) Hardware Installation Guide 2-21
Completing the Installation