Removing a Power Supply
To remove a power supply from the SSA:
1.
Put on the antistatic wrist strap and attach it to the ground receptacle on the front of the SSA
before handling a power supply. Refer to the instructions in the anti‐static wrist strap
package. See Figure
2.
Unplug the associated power cord from the AC outlet.
3.
Remove the zip tie, if present, that secures the associated power cord to the SSA.
4.
Unplug the associated power cord from the AC inlet.
5.
Unscrew the captive screws to release the power supply from the SSA.
6.
Remove the power supply by grasping the handle and pulling it straight out of the SSA.
7.
If you are not immediately installing another power supply, fasten a coverplate over the
empty power supply bay.
2‐9 on page 2‐13 for the location of the ground receptacle.
Caution: If you plan to operate the chassis with only one power supply, be sure to install the
coverplate in place of the removed power supply to contain EMI radiation and ensure proper air
circulation.
Precaución: Si desea trabajar sólo con una fuente de poder, no olvide colocar la tapa en el
compartimiento de la fuente de poder que haya eliminado, para reducir la interferencia
electromagnética y para asegurar una buena ventilación.
Enterasys S-Series Stand Alone (SSA) Hardware Installation Guide 2-15
Removing a Power Supply