Preparing For Installation - Xantrex XPLORE 120A 12V Owner's Manual

Preparing For Installation

Preparing For Installation

ELECTRICAL SHOCK AND FIRE HAZARD
Installation must be done by qualified personnel to ensure
compliance with all applicable installation and electrical codes and
regulations. Instructions for installing the XPLORE 120A 12V
Battery Charger are provided here for use by qualified personnel
only.
Failure to follow these instructions will result in death or serious
injury.
* Applicable codes in North America are the US National Electrical Code (NFPA 70) and Canadian Electrical
Code (CSA C22.1) and the American Boat and Yacht Council (ABYC) standards and US Coast Guard
Regulations (33CFR183, Sub Part I) for Marine installations in the USA.
* Applicable codes in Europe are the IEC/EN 60364-X-Y series of standards.
12
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION, BURN, OR
ARC FLASH
Apply appropriate personal protective equipment (PPE) and
n
follow safe electrical work practices.
This equipment must only be installed and serviced by
n
qualified electrical personnel.
Never operate energized with the wiring compartment cover
n
removed.
Energized from multiple sources. Before removing the wiring
n
compartment cover - identify all sources, de-energize, and
wait 2 minutes for circuits to discharge.
Always use a properly rated voltage sensing device to confirm
n
all circuits are de-energized.
Batteries can present a risk of electrical shock, high short-
n
circuit current, and exposure to gasses and chemicals.
Replace all devices, doors, and covers before turning on
n
power to this equipment.
Failure to follow these instructions will result in death or serious
injury.
XPLORE 120/12 Battery Charger Owner's Guide
DANGER