Preparing For Installation - Xantrex XPLORE 120/12 Owner's Manual

Preparing For Installation

Preparing For Installation

NOTICE
PROPER INSTALLATION BY A QUALIFIED INSTALLER
The XPLORE Charger must be installed by a qualified installer in
accordance with all applicable local or national installation codes
such as the US National Electrical Code (NFPA 70) and Canadian
Electrical Code (CSA C22.1) and the American Boat and Yacht
Council (ABYC) standards and US Coast Guard Regulations
(33CFR183, Sub Part I) for Marine installations in the USA.
Failure to follow these instructions can result in equipment
damage.
NOTE: The XPLORE Charger is designed to be permanently
mounted. Figure 4 shows a full installation with six batteries and
an AC source connection. It also shows the AC and DC wiring
and protection devices required for a safe installation. Means of
over-current protection and disconnection must be incorporated
into the fixed wiring, in accordance with the electrical code that
governs each installation.
12 XPLORE 120/12 Battery Charger Owner's Guide