Programming; Acs-Pan-A Control Panel; Control Modes - ABB ACS 400 User Manual

PROGRAMMING

ACS-PAN-A Control Panel

The ACS-PAN-A is an alphanumeric control panel with a backlit LCD display and multiple languages.
The control panel can be connected to and detached from the drive at any time. The panel can be
used to copy parameters to other ACS 400 drives with the same software version (Parameter 3301).

Control modes

Display modes
MENU
Green LED
Red LED
RESET
Control Modes
The first time the drive is powered up, it is controlled from the Control Terminal Strip X1 (remote
control, REM). The ACS 400 is controlled from the control panel when the drive is in local control
(LOC).
Switch to local control (LOC) by pressing and holding the LOC/REM button until first LOCAL
CONTROL or LOCAL, KEEP RUN is displayed:
• If the button is released while LOCAL CONTROL is displayed, the panel frequency reference is
set to the current external reference and the drive is stopped.
• When LOCAL, KEEP RUN is displayed, the current run/stop status and the frequency reference
are copied from the user I/O.
Start and stop the drive by pressing the START/STOP button.
Change direction by pressing the REVERSE button (Parameter 1003 must be set to REQUEST).
Switch back to remote control (REM) by pressing and holding the LOC/REM button until REMOTE
CONTROL is displayed.
Direction
RUN >
< RUN
RUN > (or < RUN) Arrow head blinking rapidly
> (or <) Arrow head blinking slowly
ACS 400 User's Guide
OUTPUT MENU LOC REM RUN
MENU ENTER
LOC
RESET
REM
REVERSE
LOC/REM
• Drive is running and at set point
• Shaft direction is forward (>) or reverse (<)
Drive running but not at set point.
Drive is stopped.
Run indicator
Shaft direction
UP/DOWN
ENTER
START/STOP
25