Acs100-Pan Control Panel; Control Modes - ABB ACS 400 User Manual

ACS100-PAN Control Panel

The control panel can be connected to and detached from the drive at any time. The ACS100-PAN
panel cannot be used to copy parameters between two ACS400 drives.

Control modes

Active fault indicator
Display modes
START/STOP
REVERSE
Control Modes
The first time the drive is powered up, it is controlled from the Control Terminal strip (remote control,
REM). The ACS 400 is controlled from the control panel when the drive is in local control (LOC).
Switch to local control (LOC) by pressing and holding the MENU and ENTER buttons down
simultaneously until first Loc or later LCr is displayed:
• If the buttons are released while Loc is displayed, the panel frequency reference is set to the
current external reference and the drive is stopped.
• When LCr is displayed, the current run/stop status and the frequency reference are copied from
the user I/O.
Start and stop the drive by pressing the START/STOP button.
Change direction by pressing the REVERSE button (Parameter 1003 must be set to REQUEST).
Switch back to remote control (REM) by pressing and holding the MENU and ENTER buttons down
simultaneously until rE is displayed.
Direction
FWD / REV Visible
FWD / REV Blinking rapidly
FWD / REV Blinking slowly
ACS 400 User's Manual
LOC
REM
FAULT
OUTPUTPAR SET MENU FWDREV
UP/DOWN
• Shaft direction is forward / reverse
• Drive is running and at set point
Drive is accelerating / decelerating.
Drive is stopped.
Units
mAVs
kHz %
o
Crpm
Shaft direction
MENU
MENU
LOC REM
LOC REM
ENTER
ENTER
31