Important Safety Notes - SMART fortwo coupe Owner's Manual

On-board computer and displays
90
tion button so that you can configure it for
communication with the vehicle. Connect
the adapter to the mains supply and to your
Internet access interface. If the adapter is
to be connected using a phase other than L1,
you will also need to install a phase cou-
pler. This is the only way you will be able to
ensure the communication is reliable and
secure. Please contact an electrician if
you have any questions.
i
If you already have a Powerline network
setup, you can connect the vehicle to this
network.
To connect the vehicle to a Powerline
adapter, proceed as follows:
X
Connect the vehicle using a mains socket
or wallbox.
Right indicator lamp # on the vehicle
socket must flash green.
X
Plug the Powerline adapter into a nearby
mains socket. Make sure that the vehicle
and adapter have a phase L1 connection.
X
Switch the ignition on.
X
Charge current
Call up the
on-board computer (
Carry out the following steps within
30 seconds:
X
If the charge current value is not set to
8 A: set the value to 8 A and confirm the
setting.
X
Set the charge current value to 12 A and
confirm the setting.
X
Set the charge current value to 8 A and
confirm the setting.
X
Set the charge current value to 12 A and
confirm the setting.
X
Press the encryption button on the Pow-
erline adapter within three minutes.
If the Powerline adapter indicates a con-
nection, then the connection was suc-
cessful.
i
Please also read and follow the separate
Powerline adapter operating instruc-
tions.
menu in the
Y
page 100).
i
If you have any questions, please con-
tact a smart Centre.
X
When finished, set the charge current
value back to the desired value.
As soon as the vehicle has established a
connection to the Internet, you can use the
"Vehicle Homepage" during the charging
process. Changes that you have made using
the "Vehicle Homepage" are also transmit-
ted once charging is completed. This data
transfer is terminated after approx-
imately three days.
On-board computer and displays

Important safety notes

You will find an illustration of the instru-
ment cluster in the "At a glance" section
Y
( page 22).
G
WARNING
Only use the on-board computer when road
and traffic conditions permit. You would
otherwise be distracted and unable to con-
centrate properly on driving, and could
cause an accident.
G
WARNING
No messages will be displayed if either the
instrument cluster or the multifunction
display is inoperative.
As a result, you will not be able to see
information about your driving condi-
tions, such as speed, outside temperature,
warning and indicator lamps, display mes-
sages or system failures. Driving charac-
teristics may be impaired. Adjust your
driving style and vehicle speed accord-
ingly.
Immediately consult a qualified specialist
workshop which has the necessary special-
ist knowledge and tools to carry out the
work required. smart recommends a smart
Centre for this purpose. In particular, work
relevant to safety or on safety-related sys-